

Heat exchangers for biogas plants
Heatcrack Substrate Heat Exchanger – Making optimum use of CHP waste heat for biogas plants
Heatcrack Substrate Heat Exchanger (WT-SWT-HC)
HeatCrack Substrate Heat Exchanger – Efficient heat recovery between the fermenter and post-fermenter
The HeatCrack optimally heats the biogas substrate between the fermenter and the post-fermenter. The tube-in-tube heat exchanger utilises the heating water from the CHP unit for energy-efficient substrate heating. The result: thanks to the high inlet temperature into the post-fermenter, it can be operated with virtually no additional heating energy – maximising the utilisation of waste heat from the CHP unit for your biogas plant.
Thermal substrate digestion for higher gas yield
Biogas plants are often fed with low-cost, fibre-rich substrates such as manure, grass and silage. By its very nature, this biomass contains high levels of crude fibre (lignin, cellulose), which place high demands on the technology and fermenter biology. The challenge: crude fibre is difficult for bacteria in the biogas digester to break down.
The HeatCrack solution: The substrate heat exchanger thermally treats unprocessed crude fibre components. Targeted heating breaks down cell structures and makes the substrates more readily available to the bacteria – significantly increasing gas yield.
Applications for the HeatCrack heat exchanger:
- For solids with an extremely high fibre content
- For capacity expansion
- During seasonal energy peaks
- As an external heating source in the event of a failure of the fermenter heating system
- Where the substrate has a short residence time in the fermenter
Further technical details:
The ‘thermal engineering trials’ carried out by our research laboratory yielded excellent results: in practice, the use of the substrate digestion system can increase biogas yield by up to approximately 5 per cent.
Download the product data sheet
Note:
- The transferable heat output depends on the substrate, temperature difference, flow rate and other system parameters. A specific design is determined on a case-by-case basis.
Options:
- 4-tube heat exchanger – approx. 40 – 60 kW useful output
- Heat exchanger with 10 tubes – approx. 60 – 120 kW useful output
- Heatcrack HP (High Performance – suitable for higher heating water flow rates depending on the application) – up to 400 kW net output
Service and Advice
We would be happy to provide you with comprehensive advice on our products and assist you in optimising your biogas plant.
We would be happy to provide you with a personalised quote:
Version:WT-SWT-HC_WS_001-00